Thursday, September 29, 2011

Installation Process to ceiling speakers for a surround sound system


!±8± Installation Process to ceiling speakers for a surround sound system

1 Determine the requirements for use: Before installing, you should be aware of how you're going to use in ceiling speakers. As if you use the speakers in the dining room, will be used as background music for parties, so it is best to install speakers along the perimeter of the ceiling of your room.

2 Use a tape measure to ensure that the speaker is in the room evenly. You can mark the spot with a pencil.

3 Use stud finderremoved before cutting the ceiling to make sure it did not hit any obstacles

4 Center the model cut (which was dealt with speakers) for the position of each in-ceiling speakers and select a table with a pencil. Drill a small hole in the center of the drawing.

Take 5 next to the hook. Bend at an angle of 90 degrees about 6 inches from the end. Insert the tip into the hole you made in the wall of up to 90 degree bend and twist the wireto see if the area inside the structure does not include any disability or not. It was found in case of an obstacle, remove the bracket and cut the outline with a drywall.

6 Prepare a plan to put the speaker wires

7 Use wire ribbon fish from the hole to go to the speakers for the access hole in the receiver.

8 Be careful when attaching cables.

9 Complete the installation as recommended by the statement that came with the ceiling mountSpeaker

Follow these simple steps to install the ceiling speakers with no problems.


Installation Process to ceiling speakers for a surround sound system

Bosch Meat Grinder Get It Now! Saved Touch Sensor Floor Lamp




No comments:

Post a Comment


Twitter Facebook Flickr RSS



Français Deutsch Italiano Português
Español 日本語 한국의 中国简体。







Sponsor Links